WARNING • Green blinks identify Motor 1 or 2

Lippert Schwintek Slide-Out: 1 Red Blink — Drop Out / Low Battery Voltage

Battery voltage at the controller dropped below 10.5V DC during slide actuation.

← Live Decoder
GREEN (Motor)
RED (1x)
− 1 Red Blink + Match the flashing Red LED rhythm on your V-Sync controller.
Field Safety Warning: Do not repeatedly stall the slide on low voltage; excessive amperage damages the 13398-DO controller.

Checkable Field Troubleshooting Steps

Most Probable Root Causes

  • Discharged house battery bank or dirty battery terminals
  • Converter/charger switched off or blown 30A inline fuse
  • Undersized power feed or loose ground lug at controller
Emergency Electronic Override (6-Press + 7th Hold)
  1. Locate the Schwintek V-Sync controller (usually inside a storage bay or wardrobe near the slide).
  2. Press the tiny recessed Mode Button cleanly 6 times, then press and HOLD on the 7th press for ~5 seconds until Red & Green LEDs flash rapidly.
  3. Release the button. Both motors are now in manual override—immediately use the interior wall switch to retract the slide evenly for travel.
  4. Manual Mechanical Override: Unplug Motor 1 and Motor 2 from the controller to release electronic braking, then push the room straight in with two helpers.
Deep-Dive Technical Guide
Schwintek Slide-Out Master Guide

How the Schwintek dual-motor V-Sync controller counts Hall-effect pulses, why 8 Red Blinks happens at campgrounds, how to test motors with a multimeter, and safe override steps.

Read Complete Field Guide →

OEM Replacement Parts & Cross-References

Lippert OEM: 13398-DO
Schwintek V-Sync II Dual Motor Slide Controller
Cross-Ref: 13398-C2 / 211852

Upgraded green-board replacement for older 13398-C2 modules.

Disclosure: As an Amazon Associate and eBay Partner, CodeMyRV earns from qualifying purchases at no additional cost to you. See our Affiliate Disclosure.

Frequently Asked Questions About Schwintek Slide 1R

What does Schwintek Slide fault 1R mean?

Battery voltage at the controller dropped below 10.5V DC during slide actuation.

What are the most common causes of Schwintek Slide 1R?

Discharged house battery bank or dirty battery terminals; Converter/charger switched off or blown 30A inline fuse; Undersized power feed or loose ground lug at controller.

What safety precautions apply before troubleshooting 1R?

Do not repeatedly stall the slide on low voltage; excessive amperage damages the 13398-DO controller. Always disconnect 120V shore power and shut off LP gas supply valves before probing live electrical or gas components.

Other Lippert Schwintek Slide-Out Fault Codes